dow shows the ON icon (T), and the volume icon (U). To decrease the volume of the audible signal that the detector emits when it sens- es a laser beam, push the button again; one of the half circles next to the horn icon will dissappear. To turn off the audible signal push the button a third time; the volume icon will dissapear. The DEWALT digital laser detector also has an auto
P
TU
Q
VW
When the detector is on, the bottom of the window shows an accu- racy mode icon. Either the ±1/25" accuracy mode icon (V) will appear, or the ±1/8" accuracy mode icon (W) will appear. When the ±1/25" accuracy mode icon appears, it indicates that the detec- tor will give an “on grade” reading only when the laser beam is on grade or no more than 1/25" above or below it. When the 1/8" accuracy mode icon appears, it indicates that the detector will give an “on grade” reading when the laser beam is on grade or approx- imately 1/8" above or below it. Push the accuracy mode button (S) once to change the accuracy mode.
INDICATORS
SlightlySlightly
Above Above On Below Below
|
| Grade |
|
| Grade |
|
| Grade |
| Grade | Grade | ||||||
|
| fast |
|
| fast |
|
| steady |
|
| slow | slow | |||||
audible signals | |||||||||||||||||
| beep |
|
| beep |
|
| tone |
|
| beep | beep | ||||||
|
|
|
|
|
|
|
| ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
display icons |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Detector Operation
1.Set up and position the rotary laser that you will be using according to the manufacturer’s directions. Turn the laser on and make sure that the laser is rotating and emitting a laser beam.
NOTE: This detector has been designed to be used only with a rotating laser. The detector will not work with a stationary beam laser level.
2. Turn the detector on by pressing the power/volume button (R).
3. Adjust the volume as desired as described in the Detector Controls above.
4. Position the detector so that the detector window (X) is facing the laser beam produced by the rotary laser. Move the detector up or down within the approximate area of the beam, until you have centered the detector. For information about the display window indicators and the audible signal indicators, see the table titled Indicators.
English
11
