English
such as, but not limited to, steel wool, aluminum foil, or any buildup of metallic particles should be kept away from charger cavities. Always unplug the charger from the power supply when there is no battery pack in the cavity. Unplug charger before attempting to clean.
6. Do not immerse charger in water or any other liquid.
WARNING: Don't allow any liquid to get inside charger. Electric shock may result. To facilitate the cooling of the battery pack after use, avoid placing the charger or battery pack in a warm environment such
3.Thread on blade clamping screw firmly by hand to hold washer in position. (Screw has left hand threads and must be turned counterclockwise to tighten).
4.Lightly depress the blade lock (FIG. 4) while turning the spindle until the blade stops rotating.
5.Tighten blade clamping screw (counterclockwise) firmly with the blade wrench.
as in a metal shed, or an uninsulated trailer.
CAUTION: Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack breaks or cracks, return to a service center for recycling.
Installing and Removing the Battery
Pack | FIG. 2 |
NOTE: Make sure your battery |
|
pack is fully charged. To install the |
|
battery pack into the tool handle, |
|
align the base of the tool with the |
|
notch inside the tool’s handle and |
|
slide the battery pack firmly into the |
|
handle until you hear the lock snap |
|
into place as shown in FIG. 2. |
|
6. To remove blade, TURN
OFF | TOOL | AND FIG. 3 | |||
REMOVE | BATTERY | ||||
PACK. Engage the blade | |||||
lock and | unscrew | the | |||
blade |
| clamping |
| ||
screw | by | turning it |
| ||
clockwise | with | the | BLADE | ||
blade wrench. |
| ||||
| CLAMPING | ||||
NOTE: Never engage | |||||
SCREW | |||||
blade lock while saw is |
| ||||
running, or engage in an | WRENCH | ||||
effort to | stop the | tool. | |||
| |||||
INNER CLAMP
WASHER
OUTER
CLAMP
WASHER
RELEASE BUTTON |
To remove the battery pack from
the tool, press the release buttons and firmly pull the battery pack out of the tool handle. Insert it into the charger as described in the charger section of this manual.
OPERATION
Changing Blades
1.TURN OFF TOOL AND REMOVE BATTERY PACK.
2.To attach blade, retract lower blade guard and place blade over spindle and against the inner clamp washer. Place outer clamp washer against the blade. (Blade must go on with the printed side out- teeth at bottom of blade pointing
| BLADE LOCK | FIG. 5 | |
FIG. 4 | BUTTON | BEVEL | |
ADJUSTMENT | |||
|
| ||
|
| KNOB |
LOOSEN TIGHTEN
clockwise counterclockwise
8
