Epson DW935 instruction manual Kerf Indicator, Work Piece Support

	FIG. 6
English	FIG. 7
	50
	40
	30
	20
	15
	0

6.Confirm the accuracy of the setting by checking the squareness of an actual cut on a scrap piece of material.

Kerf Indicator

The front of the saw shoe has a kerf indicator for vertical and bevel cutting. This indicator enables you to guide the saw along cutting lines penciled on the material being cut. The indicator lines up with the left (outer) side of the saw blade, which makes the slot or “kerf” cut by the moving blade fall to the right of the indicator. Guide along the penciled cutting line so that the kerf falls into the waste or surplus material..

Work Piece Support

Figure 6 shows proper sawing position. Note that hands are kept away from cutting area. To avoid kickback, DO support board or panel NEAR the cut, (FIG. 7). DON’T support board or panel away from the cut, (FIG. 8).

FIG. 8

DO support board or panel NEAR the cut.

SUPPORT

DON’T support board or panel AWAY from the cut.

WARNING: It is important to support the work properly and to hold the saw firmly to prevent loss of control which could cause personal injury. FIG. 6 illustrates typical hand support of the saw. ALWAYS TURN OFF TOOL AND REMOVE BATTERY BEFORE MAKING ANY ADJUSTMENTS!

Place the work with its “good” side–the one on which appearance is most important–down. The saw cuts upward, so any splintering will be on the work face that is up when you cut it.

FIG. 10

FIG. 9

SWITCH LOCK OFF RELEASE BUTTON

TRIGGER

SWITCH

10