![](/images/new-backgrounds/1103095/103095177x1.webp)
Problem Solving |
| 89 |
|
|
|
Refer to the following table to see what the indicators mean and how to remedy | problems that they indicate. |
|
| |||||
If all indicators are off, check that the power cable is connected correctly and that the power is being supplied normally. | ||||||||
Sometimes, when the power cable is unplugged, the t indicator remains lit for a | short period, but this is not a fault. | |||||||
|
| : | Lit |
| : Flashing | : Off |
| : Varies according to the projector status |
|
|
|
|
Status
Cause |
| Remedy or Status |
|
|
|
Internal Error |
| Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest address provided in the |
|
| Epson Projector Contact List. |
|
| s Epson Projector Contact List |
|
|
|
Fan Error |
| Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest address provided in the |
Sensor Error |
| Epson Projector Contact List. |
|
| s Epson Projector Contact List |
|
|
|
High Temp Error |
| The lamp turns off automatically and projection stops. Wait for about five minutes. After about five minutes the projector switches to standby |
(overheating) |
| mode, so check the following two points. |
|
| • Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall. |
|
| • If the air filter is clogged, clean or replace it. |
|
| s "Cleaning the Air Filter" p.101, "Replacing the Air Filter" p.106 |
|
| If the error continues after checking the points above, stop using the projector, remove the power plug from the electrical outlet, and contact |
|
| your local dealer or the nearest address provided in the Epson Projector Contact List. |
|
| s Epson Projector Contact List |
|
|
|
|
| When using at an altitude of 1500 m or more, set High Altitude Mode to On. |
|
| s "Extended Menu" p.74 |
|
|
|
Lamp Error |
| Check the following two points. |
Lamp Failure |
| • Take out the lamp and check if it is cracked. |
|
| s "Replacing the Lamp" p.103 |
|
| • Clean the air filter. |
|
| s "Cleaning the Air Filter" p.101 |
|
|
|