Your application has locked the computer, making if unresponsive to keyboard commands.

Reset the computer and try again. If resetting the computer does not help, turn it off, wait 20 seconds, then turn it on again.

Some software, like OS/2, Unix, or NetWare 3.11, needs a minimum of 4MB to 8MB of RAM to work correctly. Check your software documentation for the minimum memory requirements. If necessary, add additional memory using the instructions in Chapter 3.

Printer Problems

The printer does not work at all.

Check that the printer has power and is properly connected to the computer. Also make sure your printer has paper in it.

The printer prints garbled information.

Check the printer manual for the printer’s correct DIP switch or control panel settings.

Also, make sure you have the proper drivers installed for your printer.

Option Card Problems

A new/y installed option card is not working correctly.

Make sure the option card is installed correctly and is well-seated in its slot. Run the SETUP program to update your computer’s configuration after you install the card. Also, perform setup procedures for any software you are using with the option card.

Troubleshooting 6-9