82
Tip :
• If the projector is not operating properly even though the indicators are all showing normal, refer to "When the Indicators Provide No Help" on the following page.• If an indicator is showing a status which does not appear in the previous tables, contact your dealer or the nearest address provided on page 11 of the Safety Instructions/World-Wide Warranty Teams.
High-speed
cooling in
progress
(This is not an abnormality, but if the
temperature rises too high again, projection
will stop automatically.)
•Set th e projector up in a place which is
well-ventilated, and so that the air inlet and
exhaust vents are clear.
•Clean the air filter.
P.18
P.92
Lamp will soon
need to be
replaced.
Have a new replacement lamp ready.
The lamp service life can become shorter than
normal as a result of the usage conditions,
and so the lamp should be replaced as soon as
possible.
* The appearance of the operation indicator
at this time will vary depending on the sta-
tus of the projector.
P.94
Standby
condition (No abnormality)
Projection starts when the [Power] button is
pressed.
P.37
Warm-up in
progress (No abnormality)
Wait for a short while. The indicator will stop
flashing and light with a green color.
P.37
Projecting in
progress (No abnormality) P.37
Cool-down in
progress (No abnormality)
• W ait for a short while.
The cool-down (lamp cooling operation)
period lasts for about 2 minutes. The actual
time will vary depending on the external air
temperature.
•The [Power] button will not operate during
the cool-down period. When cool-down is
complete, the indicator will stop flashing
and light orange. You can then use the
[Power] button.
P.39
Indicator status Projector
status Problem and remedy Reference
page
red orange
orange
orange
green
green
orange
Troubleshooting