61
Appendices
RearBase
Control (RS-232C) port
Connects the projector to a computer using an
RS-232C cable. This port is for service use,
and should not normally be used.
USB port (
Setup Guide
)
Connects the projector to a computer
using a USB cable.
Remote control
light-receiving area
(
Setup Guide
)
Receives signals from
the remote control.
Rear adjustable foot
(p.12)
Extend and retract to adjust
the horizontal projection
angle.
S-Video port
(
Setup Guide
)
Inputs an S-Video
signal to the projector from
other video sources.
Audio 2 port (
Setup Guide
)
Inputs audio signals.
Audio 1 port
(
Setup Guide
)
Inputs audio signals.
Connects using a stereo
mini jack.
Computer 1 port (
Setup Guide
)
Inputs digital/analog RGB image
signals from a computer.
Computer 2/ Component Video port
(
Setup Guide
)
Inputs component video images from a video
source or analog video signals from a computer.
Monitor Out port (
Setup Guide
)
Outputs the projected analog image signal from a
computer to an external monitor.
This is not available for digital image signals being
input to the Computer 1 port or signals from other
video sources.
Remove the cover when using this port.
Video port (
Setup Guide
)
Inputs composite video signals to
the projector from other video
sources.
Speaker
Power inlet (p.6)
Connects the power cord.
Remote port
Connects an optional
remote control receiver to
the projector.
Suspension
bracket fixing points
(4 points)
(p.53,
Setup Guide
)
Install the optional ceiling
mount here when suspending
the projector from the ceiling.
Air filter (air inlet)
(p.46, 50)
Prevents dust and other
foreign particles from
being drawn into the
projector.
When replacing the lamp,
replace the air filter also.
Rear adjustable foot
Front adjustable foot
Front/ Top Rear Remote control
Control panel Base