Problem

stops automatically

When "Sleep Mode" has been set to ON, the lamp automatically if no signal is input for about 30 projector switches to standby mode. Press the control or the button on the projector's projector's power back on. To cancel

Mode" menu command to - "Operation" -

Press on the remote control or

If the "Child Lock" menu command is set to projector's control panel for about 3 seconds or control to turn the power on.

"Setting" - "Operation" - "Lock Setting" - "Child Lock"

set to "ON"? If the "Key Lock" menu command is set to "ON", all buttons on projector's control panel are disabled. Press on the remote control. "Setting" - "Operation" - "Lock Setting" - "Key Lock" p.20

Are all of the indicators

Disconnect the power cable and then reconnect it.

Setup Guide

switched off?

Check the circuit breaker to see if power is being supplied.

Do the indicators turn off and Turn the power off, disconnect the power cable and then reconnect it. If

on when the power cable is this does not solve the problem, there may be a problem with the power

touched?cable. Then contact your dealer or the nearest address provided at "International Warranty Conditions" in Safety Instructions/World-Wide Warranty Terms booklet.

Problems with the remote control

The remote control does not work

Is the remote control light-

Face the remote control towards the remote control light-receiving area.

emitting area facing towards

The operating angle for the remote control is approximately ±30º

the remote control light-

horizontally and approximately ±30º vertically.

receiving area when it is

Setup Guide

operated?

 

 

 

Is the remote control too far

The operating range for the remote control is approximately 10m.

from the projector?

Setup Guide

 

 

Is direct sunlight or strong

Set the projector up in a location where strong light will not shine onto

light from fluorescent lamps

the remote control light-receiving area.

shining onto the remote

 

control light-receiving area?

 

 

 

Are the batteries dead, or have

Insert new batteries, while making sure that they face correctly.

the batteries been inserted

Setup Guide

correctly?

 

 

 

Troubleshooting

35