Problem Solving
| Have you pressed the [Power] | Press | on the remote control or | on the projector’s control |
| button? | panel. |
|
|
| Is the main power switch | Turn on the main power switch at the rear of the projector. | ||
| turned off? |
|
|
|
| Are all of the indicators | Disconnect the power cable and then reconnect it. p.14 | ||
| switched off? | Check the circuit breaker to see if power is being supplied. | ||
Is blank mode active?Press 
on the remote control to cancel the blank function.
Is a video signal being input? Check that the power for the connected equipment is turned on. If the "Message" menu command has been set to "On", messages relating to the image signals will be displayed.
"Settings" - "Display" - "Message" p.32
Are the image signal format If a composite video
or 
settings correct?If projection does not occur when the "Video Signal" menu command is set to "Auto", select the signal format that matches the signal source.
"Settings" - "Input Signal" - "Video Signal" p.33
If the signal source is connected to the [InputA] port
If projection does not occur when the "InputA" in the "Input Signal" menu command is set to "Auto", set the signal format that matches the signal that is being projected from the connected equipment.
"Settings" - "Input Signal" - "Input A" p.33
You can also press 
on the remote control to select the
format. 
p.15
|
|
| If the VCR or DVD equipment is connected using a D4 SCART | |||
|
|
| adapter |
|
|
|
|
|
| Press | to set the signal format to "D4/SCART". | ||
|
|
| When still no images appear and the DVD equipment is connected, | |||
|
|
| change the setting at the DVD equipment to RGB output. |
| ||
|
|
|
|
|
| |
| Have the configuration menu | Try resetting all of the current settings. |
| ||||
| settings been made correctly? |
|
|
|
| ||
|
|
|
| |||
Were the projector and computer | If the connection is made while the power is already turned on, the | |||||
connected while their power was | function (Fn) key that switches the computer's video signal to | |||||
already turned on? | external output may not work. Turn the power for the computer that | |||||
|
|
| is connected to the projector off and then back on again. |
| ||
| When a computer is |
|
| |||
|
|
|
|
|
| |
| connected |
|
|
|
|
|
|
|
|
|
|
|
|
Troubleshooting
Is the computer image signal set to output simultaneously both externally and to the LCD monitor?
Only when projecting images from a laptop computer or computer with a
Set the image signal to output only externally.
Computer documentation, under a title such as "External output" or "Connecting an external monitor"
37