■If the lamp breaks, ventilate the room to prevent gases contained in the lamp from being inhaled or coming in contact with the eyes or mouth.

■If the projector is mounted overhead and the lamp breaks, be careful to prevent pieces of glass from falling into your eyes when you open the lamp cover.

WARNING: The cords included with this product contain chemicals, including lead, known to the State of California to cause birth defects or other reproductive harm. Wash hands after handling. (Provided in accordance with Proposition 65 in Cal. Health & Safety Code §25249.5 et seq.)

Remote Control Information

You can operate the projector by remote control via a line-of-sight infrared (IR) receiver at the front and rear of the projector. The projector may not respond to remote control commands under the following conditions:

■There is an object between the remote control IR emitter and the IR receiver on the projector.

■Ambient light is too bright.

■Certain types of fluorescent lighting are used.

■A strong light source shines into the IR receiver.

■Other equipment that emits infrared energy, such as a radiant room heater, is in the room.

These conditions commonly cause problems for most infrared-controlled equipment. Try the following:

■The remote control’s batteries may be low on power; replace them.

■Dim the ambient lighting and/or turn off any fluorescent lights.

■Close any window coverings and/or move the projector out of direct sunlight.

■Turn off other equipment that emits infrared energy.

Notices 103