2. Press the FF button to eject the last label form forward.
Using the Micro Adjust Function
The Micro Adjust function allows you to move the paper forward or backward in 0.141 mm
(1/180-inch) increments so that you can make precise adjustments to the top-of-form and tear-off
positions.

Adjusting the tear-off position

If the paper perforation is not in the desired tear-off position, you can use the Micro Adjust function to
adjust the position of the perforation.
Follow these steps to adjust the tear-off position.
Note:
Your tear-off position setting remains in effect until you change it, even if you turn off the printer.
1. Make sure the paper is at the current tear-off position.
2. Hold down the Pause button for about three seconds. The Pause light flashes and the printer
enters Micro Adjust mode.
3. Press the FF D button to feed the paper forward, or press the Load/Eject U button to feed the
paper backward, until the paper perforation is in the desired tear-off position.
GP-C830/GP-M830/GP-C831/GP-M831/GP-C832/GP-M832 User’s Guide
Paper Handling 23