Epson LX-86TM D, D-l, l-6, l-7, l-8, D-2, the active, international character, set as shown in Table D-2, Table D-I.DIP switch functions

Always turn the power OFF (with the switch on the right side of the printer) before you change the setting of any of these switches. Any changes made while the power is on will be ignored until you turn the printer off and back on. So set all switches with the power off.

In Table D-lwe show you the functions of all the switches. Then we explain each of them.

Table D-I. DIP switch functions

Switch 1

No.	O N	Functions	OFF
1-8	ON	International character set	OFF
1-7	ON	International character set	OFF
1-6	ON	International character set	OFF
1-5	Inactive	Paper-out sensor	Active
1-4	12-inch	Form length	11-inch
1-3	Active	Cut-sheet feeder	Inactive
1-2	Char. graphics	Character set	Italics
1-1	Condensed	Print width	Pica

Switch 2

No.	O N	Functions	OFF
2-4	Mute	Beeper	Sounds
2 - 3	CR + LF	Automatic line feed	CR only
2-2	Active	Printer-select	Inactive
2-1	0	Slashed zero	0

Note: The shaded boxes show the factory settings.

Switches l-6,l-7,and l-8determine		the active	international character
set as shown in Table D-2.
Table D-2. International DIP switch settings
C o u n t r y	Switch 1-6	Switch	1-7	Switch 1-8
USA	O n	O n		O n
France	O n	O n		O n
Germany	O n	O f f		O n
United Kingdom	O n	O f f		O f f
Denmark	O f f	O n		O n
Sweden	O f f	O n		O f f
Italy	O f f	O f f		O n
Spain	O f f	O f f		O f f

The use of international sets is discussed in Chapter 6.

D - 2