Loadingi Paper inin theTray

Make sure the printer is on and roll paper is not loaded for printing.

1Pull out the paper tray and cover.

2Lift up the paper tray cover.

3Flip up the paper guide roller and slide the edge guide all the way to the left.

4Thumb through a stack of paper, then gently tap it on a flat surface to even the pages.

2

5Load the sheets in the portrait orientation, short edge first, with the printable side face-down. Place the paper all the way back, against the right side of the tray.

Don’t load paper above the arrow mark inside the edge guide.

Caution: When you add more paper, always line up the edges with the paper already in the tray.

6Adjust the paper tray and edge guide according to the paper size. For small sheets, raise the paper guide and move it to the edge of the stack.

7Flip down the paper guide roller, then replace the paper tray cover and adjust its length.

Note: Make sure the roll paper support is not raised.

8Press the Paper Source button until you see the cut sheet icon.