24 Setting Up the Printer

Caution: You must unplug the printer from the power outlet, or you may damage the printer and the card.

Before you install the print server, make sure you check the documentation included with the card for additional instructions. Then follow these steps to install the card:

1.Turn off your computer and printer.

2.IMPORTANT: Unplug the printer from its electrical outlet. Not doing so may cause damage to the printer and the card.

Note: You need to remove the card when shipping the printer. See page 127.

3.Disconnect any interface cables from the printer.

4.Use a cross-head screwdriver to remove the two screws securing the optional interface cover. Then lift off the cover as shown:

Make sure you keep the screws in case you need to remove the card and replace the cover.

5.Slide the card along the slots inside the compartment. Push it in firmly to fully insert the connector into the printer’s internal slot.

6.Use the two screws included with the card to secure it.

7.Connect one end of the appropriate cable to the card. Then connect the other end to your computer’s Ethernet port or hub.