Notices

Important Safety Instructions

Read all of these instructions and save them for later reference. Follow all warnings and instructions marked on the scanner.

■Place the scanner close enough to the computer for the interface cable to reach it easily. Do not place or store the scanner outdoors, on an unstable surface, near excessive dirt or dust, water, heat sources, or in locations subject to shocks, vibrations, high temperature or humidity, direct sunlight, strong light sources, or rapid changes in temperature or humidity. Do not use with wet hands.

■Place the scanner near an electrical outlet where the power cord can be easily unplugged.

■Allow space behind the scanner for the cables, and space above the scanner so that you can raise the document cover fully.

■Unplug the scanner before cleaning. Clean with a damp cloth only. Do not use liquid or aerosol cleaners.

■Keep the scanner out of the reach of children.

■Use only the type of power source indicated on the scanner’s label.

■Power-supply cords should be protected from abrasion, cuts, crimping, and kinking. Be sure to place your cords to avoid any damage. Do not place objects on top of the power cord or allow the power cord to be stepped on or run over. Be particularly careful to keep all power-supply cords straight at the ends and at the points where they enter and leave the transformer.

■Connect all equipment to properly grounded power outlets. Avoid using outlets on the same circuit as photocopiers or air control systems that regularly switch on and off.

■Do not let the power cord become damaged or frayed.

■If you use an extension cord with the scanner, make sure the total ampere rating of the devices plugged into the extension cord does not exceed the cord’s ampere rating. Also, make sure the total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet’s ampere rating. Do not place multiple loads on the electrical outlet.

■Never disassemble, modify, or attempt to repair the scanner, integrated TPU, or power cord.

■Do not insert objects into any openings as they may touch dangerous voltage points or short out parts. Beware of electrical shock hazards.

Notices 15