52 Notices
Notices

Important Safety Instructions

Before using your R2000 Series, read and follow these safety instructions:
■Be sure to follow all warnings and instructions marked on this product.
■Use only the type of power source indicated on the product label.
■Place this product near a wall outlet where the plug can be easily unplugged.
■If you won’t be using this product for a long period, unplug the power cord from the
electrical outlet.
■Always turn off this product using the Ppower button, and wait until the Ppower
light stops flashing before unplugging the printer or cutting off power to the electrical
outlet.
■Avoid plugging this product into an outlet on the same circuit as a photocopier or air
control system that regularly switches on and off, or on an outlet controlled by a wall
switch or timer.
■Do not let the power cord become damaged or frayed.
■If you use an extension cord with this product, make sure the total ampere rating of
the devices plugged into the extension cord does not exceed the cord’s ampere rating.
Also, make sure the total ampere rating of all devices plugged into the wall outlet does
not exceed the wall outlet’s ampere rating.
■Avoid locations that are subject to rapid changes in heat or humidity, shocks or
vibrations, or dust.
■Leave enough room around this product for sufficient ventilation. Do not block or
cover openings in the product case or insert objects through the slots.
■Do not place this product near a radiator or heating vent or in direct sunlight.
■Do not use aerosol products that contain flammable gases inside or around this
product. Doing so may cause fire.
■Place this product on a flat, stable surface that extends beyond its base in all
directions. It will not operate properly if it is tilted or at an angle.
■Make sure this product is at least 4 inches (10 cm) away from the wall.
■Do not touch the flat white cable inside this product.
■Be careful not to spill liquid on this product.