Cleaning the Print Head

If your printouts are unexpectedly light or faint, or dots or lines are missing from the image, you may need to clean the print head. This unclogs the nozzles so they can deliver ink properly. Print head cleaning uses ink, so clean it only if quality declines.

You can clean the print head either from the printer’s control panel or using your printer software. To clean it using the printer software, the printer must be connected directly to your computer (not over a network); see your on-screen Reference Guide for details.

Caution: When you don’t turn on your printer for a long time, the print quality can decline, so turn it on at least once a month to maintain good print quality.

Follow these steps to clean the print head from the printer’s control panel:

1.Make sure the printer is turned on but not printing, and the red b error light is off.

If the red b error light is flashing or on, you may need to replace an ink cartridge; see page 51 for details.

2.Press to highlight More Options, then press OK.

3.Press or to highlight Head Cleaning, then press OK.

4.To begin cleaning, press OK. The printer makes noise and you see a progress bar on the LCD screen. Cleaning takes about 30 seconds.

Caution: Do not turn off the printer or interrupt the cleaning process.

5.When cleaning is done, run a nozzle check to confirm the print head nozzles are clean.

Make sure letter-size plain paper is loaded in the printer, then press Stop. The nozzle check pattern prints.

6.Examine the nozzle check pattern you printed. Each staggered horizontal and straight vertical line should be complete, with no gaps in the pattern, as shown below:

■If your printout looks okay, you’re done. Press OK to finish.

■If there are any gaps (as shown below), press Stop to clean the print head again.

50 Maintaining Your Printer