7.If there are no gaps in the pattern, the print head doesn’t need to be cleaned. Press OK to return to the Maintenance menu.
If there are gaps in the pattern, clean the print head as described below.
Note:
You can also check the nozzles with software when connected to a computer; see your
Cleaning the Print Head
If your printouts are unexpectedly light or faint, or you notice light or dark bands across your printout, you may need to clean the print head. This unclogs the nozzles so they can deliver ink properly. Run a nozzle check as described on page 48 to see if the print head needs cleaning.
Note:
Print head cleaning uses ink, so clean it only if quality declines and the nozzle check indicates that the print head needs to be cleaned.
1.Make sure your printer is turned on but not printing, and the ink is not low in any cartridges.
(If ink is low, you need to replace an ink cartridge before cleaning the print head; see page 51 to check ink levels, or see page 53 to replace a cartridge.)
2.Load a few sheets of
3.Press the Setup button.
4.Press l or r to select Maintenance, then press OK.
5.Press d to select Head Cleaning, then press OK.
6.Press the x Start button to begin cleaning the print head.
The printer runs a head cleaning cycle and a message appears on the LCD screen. Cleaning takes approximately 30 seconds.
Caution:
Never turn off the printer while head cleaning is in progress, or you may damage it.
7.When cleaning finishes, press the x Start button. The printer prints a test pattern like the one on page 48.
Cleaning the Print Head 49