Rev. 1.03 - 38 -
SRP-275
• Errors that are impossible to recover
Error Description ERROR LED blinking pattern Recovery
R/W error in memory
or gate array
After R/W checking, the
printer does not work
correctly.
Writing to, reading out, or
erasing the NV memory for
image scanning results
does not work correctly.
Recovers automatically
when the rear cover is
closed.
High voltage error The power supply voltage
is extremely high. Impossible to recover.
Low voltage error The power supply voltage
is extremely low. Impossible to recover.
CPU execution error
The CPU executes an
incorrect address or I/F
board is not connected.
Impossible to recover.
Print head temperature
detection circuit error.
There is an abnormality is
the print head temperature.
200ms
Impossible to recover.
NOTES
If you see this light blinking, turn off the printer for a few seconds and then turn it back on.
If the light is still blinking, call your supervisor or a service person.
• Are any of the operation panel lights on, If no operation panel lights are on, check the following:
- Make sure that the printer is turned on.
- Make sure that the power supply cable is correctly plugged into the printer and to the power outlet.
• If any of the lights are on, please check the following:
- If the POWER LED is blinking, the printer is not ready yet.
Wait until the light quits blinking and the printer is ready to use.
- If the ERROR LED is on (but not blinking), the printer is off line. Check to see that the covers are closed
and check the paper state. See Chapter 5 for instructions on installing or replacing the paper roll.
- If the ERROR LED is blinking, there is an error. In this case, turn off the printer for a few seconds and
then turn it back on. If the light is still blinking, call your supervisor or service person.
- If the PAPER OUT LED is on, check the paper roll in the printer. See Chapter 5 for instruction on
installing the paper roll.