Equator EZ 1500, EZ 3600 C/CEE service manual Applies only to models EZ 3600 C and EZ 2500 C

Problem		Possible Cause		Repair Procedure
	2b.	Blower inoperative.	2b.	Check for 115 vac at the blower motor
			terminals. Check motor resistance: 10 ohms
			maximum.
	2c. Thermostats open.		2c. Check for continuity, at room temperature.
	2d.	Thermal fuse open.	2d.	Check for continuity.
	2e.	Heating elements.	2e.	Check resistance: 25 ohms maximum open.
	2f. Dryer timer.		2f. Test for 115 vac between either terminal of
			88° C thermostat & either terminal of 110° C
			thermostat.
3. Clothes hot	3a.	Blocked filter.	3a.	Remove, clean, and replace filter.
and damp at the
end of the dry
cycle.
	3b.	*No cold water supply.	3b.	Cold water reuired for dryer to function
			properly.
	3c. * Machine not leveled.		3c. Condenser water flow disturbed. Level unit
			and retest.
	3d.	Blower impeller.	3d.	Remove and clean. Also check to see if
			condensing channel is clogged with lint.
	3e.	* Condenser water valve	3e.	Test for 110 vac across the valve terminals.
	inoperative.		If present, valve may be defective.
	3f. * Blower housing to Tub Seals		3f. Disassemble blower housing from tub.
	mismatched.		Ensure that seals are positioned properly &
			reassemble.
4. Long drying	4a.	High suds detergent.	4a.	Use Equator detergent, or other low-suds
time.			brand.
	Excessive detergent.		Measure detergent, using 2 tablespoons or 1/8
			cup maximum.
	4b.	Hot and cold water hoses	4b.	Connect hoses to the proper inlet valves.
	reversed.
	4c. Dryer section malfunction.		4c. See #2 and #3 above for tests to perform.
5. Clothes stiff	5a.	Overdrying.	5a.	Set dryer timer for a shorter cycle
and wrinkled.
	5b.	High suds detergent.	5b.	Use Equator detergent, or other low-suds
			brand.
	5c. Excessive detergent.		5c. Measure detergent, using 1 tablespoon.*

* Applies only to models EZ 3600 C and EZ 2500 C

6