Equator EZ 3600 C/CEE, EZ 2500 C, EZ 1500 service manual Problem Possible Cause Repair Procedure

Problem	Possible Cause	Repair Procedure
5. Noisy	5a. Not leveled.	5a.	Adjust levelling legs, tighten lock nuts.
	5b. Foreign object in tub.	5b.	Check tub, remove object.
	5c. Shock Absorber.	5c. Check that attachment bolts are tight.
6. Vibrates.	6a. Shipping brackets attached.	6a.	Remove & store shipping brackets.
	6b. Unstable floor	6b.	Remove carpeting, move to abeter location,
		or install underlayment.
	6c. Not leveled properly	6c. Adjust levelling legs, tighten lock nuts.
7. Water leaks	7a. Not leveled.	7a.	Adjust levelling legs, tighten lock nuts.
from detergent
drawer
	7b. Spinning with water in tub.	7b.	Not draining. See Won't drain
	7c. Electronic Control Module	7c. Test signals at Control Module. See Testing
		Electronic Control. If correct, replace control
		module. If tests between terminals 1-7 fail,
		replace timer. If tests on terminals 8, 9 or 12-15
		fail, replace motor.
	7d. Motor (tachometer).	7d.	Check tachometer resistance. See Testing
		the Drive Motor.
8. Timer doesn't	8a. Water supply off.	8a.	Check water pressure at inlet valve
advance		connections.
	8b. Filling interrupted.	8b.	See Won't Fill.
	8c. Timer.	8c. Test timer motor resistance: 2000 ohms
		max. Set to different cycle (e.g. Delicates) &
		check timer function different cycle (e.g.
		Delicates).
9. Tub rotates	9a. Electronic Control Module	9a.	Test signals at Control Module. See Testing
one direction only		Electronic Control. If correct, replace control
during wash and		module. If tests between terminals 1-7 fail,
dry cycles		replace timer. If tests on terminals 8, 9 or 12-15
		fail, replace motor.
	9b. Timer.	9b.	See above.
10. Water flows	10a. Water inlet valves leaking.	10a. Identify leaking valve. Remove and clean
into tub with		by backflushing to remove foreign material.
machine off.		Replace valve if cleaning does not correct the
		problem.

4