Set-up Steps
1 Place the worksurface on a clean floor with the top side facing down.
Carefully position the leg with the hand brake on the right end of the worksurface. Place the other leg on the left end.
NOTE: The brake cable is attached to both legs. Take care when re- moving the legs from the packaging to avoid damaging or pulling the
brake cable from the legs.
Front Edge of Worksurface | ENGLISH |
|
Rear Edge of Worksurface
2Set the right leg (with hand brake) upright on the worksurface.
Partially insert 3 of the provided
8x
# 12-14 Wood Screw
NOTE: Do not fully insert the screws into the worksurface at this time. Leave approximately 1/8” space.
3Attach one end of the sync rod to the right leg as illustrated. Make sure the brake cables don’t loop around the sync rod. See Warning, right.
Front =2 screws
Middle = 3 screws
Rear = 3 screws
WARNING
Keep Brake Cables Away from
Sync Rod and Crossbars
During Installation!
Failure to keep the brake cables away from
sync rod and crossbars may restrict lift
motion and may cause equipment damage
or personal injury! Refer to instruction
manual for more information.
5 of 14