ENGLISH
13 Install all equipment.
CAUTION! Make sure you leave 20” (508mm) of slack in all equipment cables to allow the worksurface to raise up it’s full 20” (508mm). Failure to allow enough slack in equipment cables may cause cables to get pulled, equipment to fall off desk and may result in product damage and or personal injury.
14 Adjustment Step
IMPORTANT! This product will need tension adjustments once installation is complete. Make sure all equipment is properly installed on the product before attempting range of motion or tension adjustments. Any time equipment is added or changed on this product resulting in a different mounted weight, you should repeat the adjustment steps to ensure safe and optimum operation. This product should move smoothly and easily through the full range of motion. If movement is difficult follow the adjustment instructions to loosen or tighten the tension to create a smooth, easy motion. Depending on your product and the adjustment, it may take many turns to notice a difference.
WARNING
IMPACT HAZARD
Moving Parts Can Crush And Cut
Minimize Lift Tension BEFORE:
- Removing Mounted Equipment
and
Insert 4 Stop Screws BEFORE:
- Shipping or Storing (i.e. when Desk is not upright).
To Minimize Lift Tension
Refer to installation manual for instructions on
how to minimize lift tension.
To Insert 4 Stop Screws
Refer to installation manual for instructions on
installing stop screws.
Failure to heed this warning may result in serious personal injury or property damage!
For More information and instructions visit www.ergotron.com
or contact Ergotron Customer Care at