Manuals / Ericsson / Cell Phone / Cell Phone

Ericsson GH198 user manual Steady Red Indicator Light, Changing Your Password, Messages

Models: GH198

1 68

Download 68 pages 52.37 Kb

Page 66

Steady Red Indicator Light

‘‘DISCHARGIN’’ flashes in the display. The phone has turned itself off, after the ‘‘LOW BATT’’ alarm has been issued several times. Refer to the chapter

Batteries and Recharging.

Changing Your Password

To prevent unauthorized use of the Call Barring service, a Password must be entered. See the description of Special Function No, 3. Call Barring in the chapter Special Functions.

To change the password, common to all call barring services, proceed as follows:

1.Enter the following sequence:

0 3 3 3 0 OLD PASSWORD		*	NEW
PASSWORD *	NEW* PASSWORD #

2.Press Send. *

Messages

There are a number of other messages that may be displayed.

‘‘BARRED’’

An outgoing call has failed because call barring is activated, or the number you have called has barred incoming calls.

‘‘TMP BARRED’’

Calls are temporarily barred by the network. Try again.

‘‘BARRING OF’’ (Barring Off) Call barring is cancelled.

‘‘BARRING ON’’

Call barring is activated.

‘‘COMMAND ERROR’’ -- -- -- ‘‘COMMND ERR’’

The network has rejected a request for a service that does not agree with another service already activated, or you have tried to access a service thar you have not subscribed to.

‘‘FORWRD OFF’’

Call forwarding is cancelled.

‘‘FORWARD ON’’

Call forwarding is activated.

‘‘FORWARDING’’

You are informed that an incoming call is forwarded to another number.

‘‘FWD ACTIVE’’

A reminder that call forwarding is activated.

‘‘FWD IN’’

In incoming call has been forwarded from another phone number.

‘‘FWD END’’

An outgoing call is forwarded to another number.

‘‘NETWORK PROBLEM’’ -- -- --

‘‘NETW PROBL’’

Communication with the network has failed. Try again.

Image 66

Ericsson GH198 user manual Steady Red Indicator Light, Changing Your Password, Messages

Contents

Ericsson Ericsson Mobile Communications AB Innovatron PatentsSafety and Precautions 1208/4/P/502763Contents Special Functions Introduction About this manualRecharg Overview Key functions Electronic lock SIM -- Subscriber Identity ModulePIN -- Personal Identification Number Observe the followingTurning the Phone On PIN check enabledMaking the Phone Ready for Use SIM not insertedServ indicator flashes Message ‘‘NO NETW’’ No Net- work is displayedEntering a Phone Number Making a CallIf a number contains more than 10 digits Ending the call If a call is unsuccesfulSee also the chapter Dialling Memory and Scratch Pad Receiving a Call Call Time MeterScratch Pad Volume ControlMicrophone Mute Key LockAlphanumeric Field Status IndicatorsDisplay Numeric FieldFunction Alphabetic ModeCall UseKeypad Recall Store Clear MODE/MUTEAlphabetic mode letter mode PowerVolume control EndChapter Basic Operation Mute -- Privacy keyNumeric keys Illumination Audible SignalsRinging Signal Star and HashError Signal Visual SignalsAlarm Signal Confirmation ClickStoring Numbers Storing a Number and NameMemory Protection Memory FullErasing a Stored Number and Name Scrolling through the Memory Numeric and Alphabetic ModeRecalling a Number Using Numeric Mode Alternative Method for Recalling a NumberRecalling a Number Using Alphabetic Mode Speed CallingAppending Digits to a Recalled Number Replacing the Last Digits of a Recalled NumberRecalling the Last Six Numbers Called Dialling MemoryScratch Pad Storing a NumberRecalling a Number Sending Dtmf Signals Sending a CodePre-programmed Dtmf Signalling To send the codeText in the display Special Function ‘‘RETRY OFF’’Accessing a Special Function Using MethodUsing a Combination of the Two Methods Changing a SettingStoring a New Setting Leaving a Special FunctionCall Forwarding Ringing Signal VolumeKey Clicks, Silent Keypad or Dtmf Signals ###Cancelling ALL call forwarding services ‘‘IF BUSY’’ ‘‘NO REPLY’’ ‘‘UNREACHABL’’Call Barring ‘‘ACTIVATE’’ appears ‘‘CANCEL ALL’’‘‘CHG PASSW’’ ‘‘BARRING ON’’ orChanging your password ‘‘CHANGE PASSWORD’’ -- -- -- ‘‘CHG PASSW’’ is displayedAutomatic Re-try Available Networks Back LightCurrent Network ‘‘LIGHT AUTO’’ or ‘‘LIGHT OFF’’ or ‘‘LIGHT ON’’Network Selection Mode Automatic Network SelectionList of ‘‘Preferred’’ Networks Reviewing the list of networksDeleting a network Last Call Time Total Call TimeMinute Minder DigitSIM Unblocking Key Unblocking ProcedurePIN Enabling/Disabling the PIN CheckArea Code Any KeyLanguage Selection ‘‘ANYKEY OFF’’ or ‘‘ANYKEY ON’’, is displayedEntering and storing the area code Battery DischargeBattery Voltage Turning the Area Code facility on or OFFAuto lock Phone LockFull lock Changing your security codeEnabling the electronic lock Disabling the lock or changing the lock levelStandard battery Slimline battery High-capacity Battery BatteriesCare and Maintenance Low battery alarm during a callInserting and Removing a Standard or Slimline Battery Removal InsertionInserting and Removing a High-Capacity Battery Slide indicator RechargingConnecting the basic charger Basic ChargerRecharging a standard battery Hands-Free Vehicle Kit Portable Hands Free Vehicle Power Adaptor and Rapid Charger Recharging a battery and powering the phone Connecting the multi charger Multi ChargerRecharging a battery using the horizontal compartment Recharging a battery using the vertical compartmentObserve the following Flashing Red Indicator Light -- Alarm Signal Sounds Serv Indicator FlashesReceived Signal Is Weak Phone Does Not Come OnSteady Red Indicator Light Changing Your PasswordMessages Password changing was successful ‘‘UPDATE ERROR’’ ‘‘SIM UPDATE’’ or‘‘SIM SECUR’’ or Inserting the SIM