Quick Start Guide: Connect-Power-Configure

2. Switch on the AC power supply to the unit at the wall or rack outlet.

Note: The RX8200 Receiver does NOT contain a power on/off switch.

3.After a short period of initialization the following screen is displayed on the Front Panel:

INITIALIZING

4.3.2 (Bank 0)

4.During initialization, confirm that the Status LED is on and all Up, Down, Left, Right, Edit and Save pushbuttons are lit.

3.2.2Power Up Operating Modes

When the equipment is switched on it will assume the control mode that was set when the power was turned off. This could be either:

• Local Front Panel/Web Browser control

• Director NCP control.

3.3Configuring the Inputs

3.3.1Transport Stream (ASI) Input

To configure the unit for ASI input:

1.Select ASI input from sub-menu Select Input.

3.3.2Satellite (DVB-S or DVB-S2) Input (if fitted)

Ensure that the incoming feed is connected to connector RF IN 1.

To configure the unit for Satellite input, navigate to the front panel Input menu Source # Configure menu and carry out the following steps:

1.Select SAT input

2.Set the LNB frequency

3.Set the Satellite frequency

4.Set the Symbol Rate

5.Set the Modulation scheme and FEC

6.Set the Roll-Off

7.Set the set the LNB power output

EN/LZT 790 0009 R1A 2011-03-30

13 (44)