Front Panel
AINPUT
Turn this knob to select an input.
In the setup mode, use this knob to change settings.
BPower indicator
Blue (on)
The POWER button of the main unit is ON.
Red (standby)
When the POWER button is depressed, press the STANDBY button of the remote control unit to turn the unit standby.
In the standby mode, press the ON button of the remote control unit to turn the unit ON.
Off
The POWER button of the main unit is OFF.
CPOWER
Use this button to turn the unit on and off.
DSETUP
Press this button to enter or exit the setup mode (see pages
ERemote control sensor
Receives signals from the remote control unit. Point the remote control unit at this sensor when operating the remote control unit.
FDisplay
GWORD
Use this to turn on or off the word sync function. The indicator lights when the word sync is on.
HMUTING
Use this button to mute the sound.
IVOLUME
Turn this knob to adjust the volume.
Display
ai.LINK indicator
After a future hardware upgrade (charged), this indicator will light when the INPUT knob is set to “i.LINK” or when “i_RC” is set to ON (see page 17).
This indicator blinks when the unit cannot perceive the digital signal.
bSETUP indicator
Lights while in the setup mode.
cMessage area
Normally, “current input” and volume are shown on the display.
“OPT” or “COAX” blinks when the unit cannot perceive the digital signal from the OPTICAL or COAXIAL terminal.
After a future hardware upgrade (charged), if a device is connected to the i.LINK (AUDIO) terminal, the display will show its model name (such as
“UNKNOWN” will appear if the unit cannot find the model name.
dChannel indicators
When the INPUT knob is set to “i.LINK” after a future hardware upgrade (charged), channels selected in the “CH” setup will light (see page 17).
Remote Control Unit
ASTANDBY/ON
When the POWER button of the main unit is depressed, press the STANDBY button to turn the unit standby.
In the standby mode, press the ON button to turn the unit ON.
When you press the ON button, white buttons on the remote control unit light for several seconds.
BVOLUME
Use these buttons to adjust the volume.
CDIMMER
Use this button to change the brightness of the front panel display.
DSETUP
Use this button in “Settings for Word Sync, Volume and i.LINK” on page 16.
Note that this button doesn’t work in “gain setting” or “name and skip setting” (see pages 14 and 15).
EMUTING
Use this button to mute the sound.
FINPUT
Use these buttons to select an input.
GButtons for the basic operation of Esoteric SA-10, SZ-1 or UZ-1
You can use these buttons to operate Esoteric
Point the remote control unit at the remote sensor of the SA- 10,
ENGLISH
11