Settings for Word Sync, Volume and i.LINK
INPUT SETUP
1If you want to change “W_OUT (Word sync output frequency)”, select an input to be changed by turning the INPUT knob.
“W_OUT” can be set independently for each input, while “S_VOL” is applied to all inputs.
2Repeatedly press the SETUP button to select the menu item to be changed.
If you leave the unit idle for 10 seconds, the setup mode will be cancelled.
3Turn the INPUT knob to select the options within the menu item.
<Repeat steps 2 and 3 as required.
4Repeatedly press the SETUP button (or leave the unit idle for 10 seconds) to exit the setup mode.
<Settings are stored even when power is turned off and the unit is unplugged. If left unplugged for an extended period, the settings may be lost.
Available menu item and options
W_OUT (Word sync output frequency)
Select the frequency of the word sync signal. The factory setting is “100”.
100 aq 44.1 aq 88.2 aq 176(176.4) aq 48 aq 96 aq 192
<The word sync signal is output only when the WORD button is set to “W`_OUT” (see page 13).
S_VOL (starting volume)
OFF (default)
The unit turns on with the last volume adjusted by the VOLUME knob.
“- - -” to “–20dB”
The unit always turns on with the volume you set here.
The level can be adjusted in 1 dB steps from - - - (– ∞ : no sound) to
“CH” and “i_RC” (settings for i.LINK) will be added after a future hardware upgrade (charged).
(Normal display)
Select this to exit the setup mode.
16