ATTENTION: Study the control board and read this section

thoroughly before attempting to operate your gate opener.

&%
Warnings:
•Before attempting any job on the control board (connections, maintenance), turn
off electrical power and unplug the support battery.
•Install a surge protector upstream of your opener, the opener is not power surge
proof nor will power surge damage be covered under warrantee.
•Always separate power from control and safety cables (push-buttons, receivers,
photocells, etc.). To avoid any electrical noise, use separate sheaths or a shielded
cable (with earthed shield).

%&

%&

LED Programming LEDs
P Power ON and diagnostics LED
P1 “Function” programming push-button
P2 “Value” programming push-button
F1 Battery and motor fuse - F15A
J1 Accessories Terminal board
J2 Transformer Terminal board
J3 Motor connection terminal
J4 Battery connector
J5 Minidec connector/RP receiver
P Power ON and diagnostic LED
F1 Battery and motor fuse - F15A
J2 Bus connection terminal board
J3 Motor connection terminal board
J4 Battery connector

