"
1. The control box must be mounted near your actuator arm.
The wire on the back of the actuator arm cannot be shortened or
lengthened.
Keep you control box in a location at least 3 feet off the ground to avoid
water buildup.
2. Level your box and mark your mounting holes. The
holes are located in four corners of the control box
(fig 1).
3. After marking your holes drill them and attach the
control box to the post.
4. There are three separate knockouts on the bottom of the
control box. Find a water-tight connector at your local
hardware store that will fit one of the knockout as well
as fit all of your wires through it. Remove the neces-
sary knockout in the bottom of the box and affix a
watertight connection (fig 2).
+$%$&,Fig 1
Fig 2
Your box must be kept water-
tight. Moisture can damage
your control board.
If you have trouble locating a water-
tight connector contact Estate Swing
1-800-640-GATE for assistance.