Replace any tire or wheel found to be damaged.
Operating your ATV with damaged tires or wheels is dangerous. Damaged tires or wheels can result in a sudden loss of tire pressure and control which could result in injuries.
Check your tire pressure before each riding session and at each refueling operation. Always check the pressure when the tires are cool. Use the tire pressure gauge that came with your ATV to check the tire pressure.
Tire Pressure
Recommended tire pressures are:
Front | Min | 3.2psi / 0.23kg/cm | |
Max | 4.0psi / 0.28kg/cm | ||
| |||
Rear | Min | 3.2psi / 0.23kg/cm | |
Max | 4.0psi / 0.28kg/cm | ||
|
Wheel Nut torque
Spark Plug
Replace spark plug at the beginning of each season with a replacement plug
NGK – CR8E.
Disconnect spark plug wire.
Clean dirt from around spark plug base with brush or air.
Remove spark plug with spark plug wrench.
Set the spark plug gap on the new plug to 0.023” Install the new plug screwing it in finger tight and then use the plug wrench to screw the plug in another ½ turn.
Inspect the spark plug wire for cuts, nicks or other damage. Replace as needed.
Spark Arrestor Screen
Required maintenance and cleanout:
1.After every 1800Mi / 6000Km of operation the muffler should be cleaned by removing the clean out bolt by using a 12mm wrench.
2.After every 1800Mi / 6000Km of operation the Spark Arrester has to be cleaned by loosening the retaining nut using a 10mm socket. Using pliers turn the sleeve of the Spark Arrester counterclockwise and pull out. Clean the screen with an exhaust cleaning solution and replace, securing it by tightening the retaining nut.
3.After every 2 years of operation the Spark Arrester has to be replaced by loosening the retaining nut using a 10mm socket or wrench. Using pliers turn the sleeve of the Spark Arrester counterclockwise and pull out. Replace a new Spark Arrester and secure it by tightening the retaining nut.
Air Filter
Air Filter Maintenance
Page 16
