Park the unit on a level surface and lock the parking brake.
Place the transmission gear selector switch in the “N”, Neutral, position.
Insert the key into the ignition switch and turn to the “ON” position.
Turn the engine stop switch to the “ON” position.
Set the manual choke lever to the full left position (Choke close or on)
Apply front or rear brakes.
Apply slight pressure to the throttle lever. Press the starter button on the
Your unit should start within 10 seconds of pushing the starter button. If the unit fails to start check the following.
1.Engine stop switch is “ON”.
2.Parking Brake Locked “ON”.
3.Transmission selector switch in the “N” position.
4.Set the manual choke lever to the full left position (Choke close or on)
Driving your ATV
Your ATV should only be driven in an area that is designated for this use. Insure that the area is free of obstacles and other dangers that could cause a loss of control. Check with your local authorities for any regulations regarding the use of your ATV.
Always keep your feet on the footrests and your hands on the handle bar grips while operating your ATV. Doing so will give you the best control of the unit.
Start your ATV by following the starting procedure above and allow the engine a few minutes to warm up before releasing the parking brake.
Start the unit by slowly increasing the throttle until the unit begins moving.
Turning your ATV
Learning to turn your ATV requires you to learn to shift your weight and control the
throttle to allow the rear wheels to turn properly. When making a turn, the wheels on the outside of the turn must travel a wider radius and thus a greater distance than the inside wheels of the turn. Since the rear axle does not permit a different rate of rotation, it is not enough to merely steer your ATV into the turn.
To turn properly, steer in the direction of the turn and lean your body to the inside of the turn while supporting your weight on the outer footrest. Use the throttle to maintain power throughout the turn.
If you do not use this turning technique the unit will have a tendency to continue in a straight line. If this occurs, release the throttle lever to allow the unit to stop.
Avoid braking or accelerating until you have regained directional control.
Parking Your ATV
1.Always park your ATV on a level surface.
2.Turn the ignition key to the “OFF’” position to stop the engine.
3.Set the engine stop switch to “OFF” position.
4.Engage the parking brake locking button.
5.Turn the fuel valve to the “OFF” position.
6.Remove the ignition key to prevent unauthorized use or theft of your ATV.
Page 23