Eton G1000A 4BASIC OPERATIONS, Batteries, Power On/Off/Volume, Fm Radio, 4.AM/SW1-8RADIO, Antenna

G1000A OPERATION MANUAL

4BASIC OPERATIONS

1.BATTERIES

Remove the battery compartment cover by pushing it in the direction of the arrow. Install two ‘AA’ batteries according to the polarity symbols (+ and -) marked next to the compartment.

For easy removal, place the batteries on top of the lift-out ribbon.

2.POWER ON/OFF/VOLUME

Turn the radio on by switching the power on/off switch (11). Use the volume knob (21) to adjust the volume.

3.FM RADIO

Select the FM band by using the band selector switch (13).

Use the tuning knob (6) to tune the radio to the desired frequency. When a strong signal is found, the TUNE indicator will light.

If you are using an earphone to listen to FM stereo, the

FM ST. LED (5) will light. Note that the frequency of the station appears in the display (3).

4.AM/SW1-8 RADIO

Select the desired band, AM or SW 1-8, by using the band selector switch (13). Turn the tuning knob (6) to the desired frequency \ which appears in the display (3) or just tune around and listen for stations. Note that MW appears in the display when AM is seleced. That’s because the AM band is called MW (for medium wave) in some parts of the world. SW appears in the display when SW 1-8 is selected.

5.ANTENNA

A.For AM (MW) the radio uses an internal, directional, ferrite bar antenna. Rotate the radio for best reception.

B.For FM/SW, fully extend the telescopic antenna (1). For FM, rotate it for best reception.

7