Eureka 410 N O P, HOW TO MAINTAIN continued How to Remove Blockages, Automatic Motor Shut-Off

Models: 410

1 13
Download 13 pages 55.35 Kb
Page 10
Image 10
●N

N

O

P

O

Q

FIG. 12

ENGLISH

HOW TO MAINTAIN (continued)

How to Remove Blockages

Turn the unit over on its top, brushroll facing up. Remove the two screws holding the access door to the clean out port . Remove any blockages from the clean out port and brushroll areas, then replace the access door and two screws.

AUTOMATIC MOTOR SHUT-OFF

To protect from overheating, this vacuum cleaner is equipped with a thermostat which automatically shuts off the suction motor if it overheats. Should this happen:

Step 1: Turn off the switch and unplug the cleaner because the thermostat will allow the cleaner to automatically start running again when the motor cools (approximately 30 minutes).

Step 2: Check the dust cup and filter regularly, as a full dust cup or dirty filter could cause the motor to overheat.

Step 3: Call a Eureka Authorized Warranty Station if the cleaner will not operate after cooling for approximately 30 minutes.

ESPAÑOL

MANTENIMIENTO (continuación)

Eliminación de Obstrucciones

De vuelta la unidad, de manera que el cepillo circular quede mirando hacia arriba. Retire los dos tornillos que mantiene la puerta de acceso unida al puerto de limpiado .. Elimine la obstrucción que se encuentre tapando las áreas del puerto de limpiado y del cepillo circular y luego vuelva a colocar la puerta de acceso y los dos tornillos.

CORTE AUTOMÁTICO DEL MOTOR

Para protegerla de que se recaliente, esta aspiradora viene equipada con un termostato que apaga automáticamente el motor si se recalienta. Si esto sucede:

Paso 1: Apague el interruptor de corriente y desenchufe la aspiradora porque el termostato permitirá que la aspiradora arranque automáticamente cuando el motor se enfríe (aproximadamente 30 minutos).

Paso 2: Revise la manguera, el recipiente para polvo y el filtro regularmente ya que la manguera obstruida, el recipiente para polvo lleno o el filtro sucio puede causar que el motor se recaliente.

Paso 3: Llame al Servicio de reparaciones y partes de Eureka si la aspiradora no funciona después de haberse enfriado aproximadamente 30 minutos.

10

Page 10
Image 10
Eureka 410 N O P, HOW TO MAINTAIN continued How to Remove Blockages, Automatic Motor Shut-Off, Corte Automático Del Motor