HOW TO ASSEMBLE (Continued)
Step B Attach Handle
CAUTION: Do not catch cord under handle.
Tab
5
Ledge
Groove 4
Groove
4.From rear of cleaner, align handle with groove and slide onto cleaner. If necessary, use thumb and finger pressure to slide handle into position.
5.Once handle is in place, check that the hose adapter tab is completely secure under the ledge of the handle.
6.Attach handle with two 5/8 inch screws in the assembly packet. Use either a slotted or Phillips® head screwdriver.
7.Replace front cover.
Step D Check Disposable Dust Bag
8. | Remove front cover, |
|
|
| grasp both sides of |
|
|
|
|
| |
| bag cover near top. | 8 | |
| Push thumbs against | ||
| center of cover and |
|
|
| pull out on sides. |
|
|
9. | Check to be sure the |
|
|
| paper bag collar is |
|
|
| secure with the hose | 10 |
|
| adapter inside the |
| |
| paper bag collar. |
|
|
10. | Replace front bag |
|
|
| cover. |
|
|
9
Hose Adapter
Paper Bag Collar
4
Step C Store Hose and Accessories
Combination
Tool
Hook
Crevice
Tool
Carrying
Handle
Extension Wand or Wands
HEPA Filter (on some models)
Tabs
Hose
Retainer
Step E Store Electrical Cord
11.You will find your cord retainer either at the bottom of the upper cord hook or on the handle above the upper cord hook. Firmly push the electrical cord down into either cord retainer. This will place the cord out of the way the next time you vacuum.
12.Next wind the cord around the two cord hooks on the left side of cleaner. On some models the upper cord hook turns to release the cord. Turn the hook up to store the cord.
NOTE: For easier access to bag compartment, when you store the electrical cord use a figure 8 pattern.
13. Secure the plug to the cord to prevent unwinding.
11 | Cord | Cord | 11 |
Retainer |
| ||
|
| Retainer | |
CordHook 12
12 
Cord Hook
