Eureka 8810-8849 SERIES manual How to Maintain YourVacuum Cleaner, Maintain Brush Roll

How to Maintain YourVacuum Cleaner

! Make sure vacuum cleaner is turned off and power cord is unplugged

Maintain Brush Roll

Motor can become hot with normal use.

Do not remove end caps. Remove hair and threads from brush roll periodically.

Check EXT-U Belt. Replace if worn, cut or out of shape

! Avoid touching the motor shaft when checking brush roll or belt.

1)Use handle release to lower handle flat onto floor. Turn vacuum over on its backside and remove 4 screws (Fig. 1).

2)Turn vacuum over to front side and remove brush roll cover (Fig. 2).

3)Remove brush roll and belt (Fig. 3).

4)Thread new belt around motor shaft and then the brush roll (Fig. 4).

5)Insert left end of brush roll first and then the right end (Fig. 5).

6)Rotate brush roll 2 turns to center belt.

7)Replace brush roll cover (Fig. 2). Turn vacuum over on its backside.

8)Replace screws ➌&➍ closest to the brush➀roll➁first. Then replace screws & (Fig 6).

➀	➁
➂	➃
Fig. 1

Fig. 3

Fig. 5

Fig. 2

Fig. 4

➀	➁
➌	➍
Fig. 6

Change Light Bulb

!Make sure vacuum is turned off and power cord is unplugged.

1)Lower handle to floor and remove HEPA filter.

2)Unscrew the lens and remove old bulb (Fig. 7).

3)Replace with bulb rated 12v., 10w., Type 904. Push in new bulb, replace lens cover and replace screw (Fig. 8).

4)Replace HEPA filter and return to upright position.

Fig. 7

Fig. 8

4 Eureka Customer Service HELPLINE 1-800-282-2886 www.eureka.com