Euro-Pro 372H instruction manual Or O Or B, Drawing UP the Bobbin Thread

DRAWING UP THE BOBBIN THREAD

1.Hold the end of the needle thread with your left hand.

2.Turn the balance wheel slowly towards you with your right hand until the needle goes down and comes up. Then stop the balance wheel when the take-up lever is at its highest position.

Lightly draw up the needle thread forming a loop with the bobbin thread.

3.Puil about 15cm (6 inches) of both threads away from you

under the presser foot.

STRAIGHT STITCH AND ZIGZAG STITCH

needle thread

1

2

needle

thread

bobbin

thread

3

English

		Model 377		Model 374			Model 373/372/372H
Presser foot		zigzag foot		zigzag foot
Pattern selector	M (	) or O (	) A (	) or B (		) (			(for straight stitch)
								)
	(for straight gtitch)		(for straight stitch)		(		)		(for zigzag stitch)

1 - 5 (54321) (for zigzag stitch) C ( ) (for zigzag stitch)

Stitch length dial 0.3-4 0.3-4 -

Starting Sewing

1.Be sure both the threads are drawn back under the presser foot.

2.While holding the threads with your left hand, turn the balance

zigzag foot

wheel toward you to bring the needle into the fabric where you wish to start sewing.

3.Lower the presser foot, and press the speed controller gently, then start sewing slowly.

*Sew a few reverse stitches by pushing reverse button for reinforcing the end of seams.

*Raise the needle to its highest position before turning the pattern selector dial and stitch width dial.

11