Euro-Pro EP603H Precautionary Measures, Operating Instructions, Trouble Shooting Guide, Problem

PRECAUTIONARY MEASURES

OPERATING INSTRUCTIONS

IMPORTANT: If the suction opening in the unit or the hose is BLOCKED, switch off the vacuum cleaner and remove the blocking substance before you start the unit again.

Motor Thermostat

IMPORTANT: This unit is equipped with a motor protective thermostat. If

•	If clogged hose or filter is found,
	unclog the hose and replace the
	filters.
•	Wait at least 45 minutes before

1.Do not operate the vacuum cleaner too close to heaters, radiators or cigarette butts.

4.	When pulling out the power plug
	from the wall outlet, pull the plug not
	the power cord.
5.	Do not pick up anything that is

for some reason the vacuum cleaner should overheat, the thermostat will automatically turn the unit off. Should this occur:

•Push the On/Off button once.

•Disconnect the plug from the power source.

•Check the source of overheating problem. (i.e. clogged hose or filter)

attempting to reuse the vacuum.

• After unit has cooled down for

45 minutes, plug in the cleaner

and push the On/Off button. The

vacuum should start again.

• If the vacuum still does not start,

contact customer service at

1-800-798-7398.

2.Before inserting the power plug into the wall outlet, make sure that your hands are dry.

3.Before you start vacuuming, make sure to remove large or sharp objects that might damage the dust cup debris screen.

burning or smoking such as

cigarettes, matches or hot ashes.

6. Do not use without ALL filters in

place.

Warning: Hold the plug when rewinding the cord. Do not allow the cord to whip when rewinding.

TROUBLE SHOOTING GUIDE

PROBLEM		POSSIBLE REASON	POSSIBLE SOLUTION
			1.	Plug unit in firmly.
	1.	Power cord not firmly plugged into	2.	Check fuse or breaker. Replace
VACUUM WILL		outlet.		fuse/reset breaker.
	2.	No power in wall outlet.	3.	Call 1-800-798-7398.
NOT OPERATE
	3.	Needs servicing.	4.	Turn the unit off and unplug from
	4.	Thermostat has tripped.		outlet. Allow unit to cool down,
				then restart.
			1.	Empty and clean dust cup.
VACUUM WILL	1.	Dust cup is full.	2.	Turn unit off and unplug from
	2.	Unit clogged.		wall outlet. Remove Dust Cup
NOT PICK-UP OR	3.	HEPA Filter needs cleaning or		Filter and check for object(s) in
SUCTION POWER		replacing.		air duct and remove.
IS WEAK	4.	Debris screen needs cleaning.	3.	Clean or replace HEPA Filter.
	5.	Filters need cleaning	4.	Clean debris screen.
			5.	Clean Filters
DUST ESCAPING	1.	Dust cup is full.	1.	Empty and clean dust cup.
FROM VACUUM	2.	Dust Cup is not installed correctly.	2.	Review Dust Cup instructions.
VACUUM, HOSE			1.	Remove hose and/or brushes.
	1.	Hose clogged.		Remove obstruction from hose
OR BRUSHES
	2.	Dust cup is full.		and /or brush.
WILL NOT PICK-UP
			2.	Empty and clean dust cup.

3 8