Warning: Always disconnect from power source when servicing or cleaning the unit. Failure to do so could result in electrical shock or personal injury from cleaner suddenly starting.
Warning: Always disconnect from power source when servicing or cleaning the unit. Failure to do so could result in electrical shock or personal injury from cleaner suddenly starting.
Changing the Power Nozzle Belt:
A)Occasionally the power nozzle drive belt will require changing, the frequency will depend upon the amount of use your vacuum sees.
B)Turn unit “Off” and unplug from wall outlet.
C)Use a Phillips screwdriver and remove the two screws from the back of the motorized power head cover. (Fig. 1)
D)Remove the two screws from the bottom of the motorized power head. (Fig. 2)
E)If the belt has broken, remove any loose pieces before replacing.
F)Grasp the beater bar at either end and lift straight up.
G)Place one end of new belt over motor shaft and the other on the round pulley end of the beater bar. (Fig. 3)
H)Align the rubber supports at the ends of the beater bar, with the slots in the motorized power head. Push into place. Ensure that the
I)Replace the two screws from the bottom of the motorized power head and then replace the cover. Then replace the two screws from the back side of the motorized power head.
Changing the Head Light Bulb:
A)Turn unit “Off” and unplug from wall outlet.
B)Insert the edge of a flat edge screw driver into the locking tab on the headlight lens and pull the handle of the screw driver towards you. Do NOT push with the blade of the screw driver against the lens because it might cause it to break.
C)Remove the lens. (Fig. 4)
D)Remove the light bulbs by pulling them out carefully.
E)Push the new light bulbs in and replace the lens cover.
F)Make sure that it snaps in place.
Note: Always replace the light bulb with the same or smaller wattage size (12V 4W) to prevent damage to the surrounding parts.
Fig. 4
Changing the Power Nozzle Belt:
A)Occasionally the power nozzle drive belt will require changing, the frequency will depend upon the amount of use your vacuum sees.
B)Turn unit “Off” and unplug from wall outlet.
C)Use a Phillips screwdriver and remove the two screws from the back of the motorized power head cover. (Fig. 1)
D)Remove the two screws from the bottom of the motorized power head. (Fig. 2)
E)If the belt has broken, remove any loose pieces before replacing.
F)Grasp the beater bar at either end and lift straight up.
G)Place one end of new belt over motor shaft and the other on the round pulley end of the beater bar. (Fig. 3)
H)Align the rubber supports at the ends of the beater bar, with the slots in the motorized power head. Push into place. Ensure that the
I)Replace the two screws from the bottom of the motorized power head and then replace the cover. Then replace the two screws from the back side of the motorized power head.
Changing the Head Light Bulb:
A)Turn unit “Off” and unplug from wall outlet.
B)Insert the edge of a flat edge screw driver into the locking tab on the headlight lens and pull the handle of the screw driver towards you. Do NOT push with the blade of the screw driver against the lens because it might cause it to break.
C)Remove the lens. (Fig. 4)
D)Remove the light bulbs by pulling them out carefully.
E)Push the new light bulbs in and replace the lens cover.
F)Make sure that it snaps in place.
Note: Always replace the light bulb with the same or smaller wattage size (12V 4W) to prevent damage to the surrounding parts.
Fig. 4
Lens locking tab
Fig. 1 | Fig. 2 |
Lens locking tab
Fig. 1 | Fig. 2 |
Fig. 3 | Fig. 3 |
|
