Euro-Pro S3601CO manual Getting Started cont’d Using Your Steam Mop

Getting Started - cont’d

Using Your Steam Mop

English

fig. 2 fig. 4

fig. 5

fig. 3

IMPORTANT: Make sure you don’t use the mop without attaching a micro-fiber cleaning pad and adding water to the tank first. When you are using the mop for the first time, it might take longer than the normal 30 seconds to start steaming.

fig. 7

fig. 6

2Use the lavender loop on the side of the micro-fiber cleaning pad to slide mop head into pad pocket. Then secure the quick fasteners on the top of the pocket to lock in place.

(fig. 2)

3Snap the mop head into the base to secure it. (fig. 3)

4Turn the water tank cap counter clockwise and remove from the tank. (fig. 4)

Use the filling flask and pour water into the tank. Please don’t overfill. Replace the cap on the water tank. (fig. 5)

IMPORTANT: Don’t use on unsealed wood or unglazed ceramic floors. On surfaces that have been treated with wax or some no wax floors, the sheen may be removed by

the heat and steam action. It is always recommended to test an isolated area of the surface to be cleaned before proceeding. We recommend that you check the use and care instructions from the floor manufacturer.

IMPORTANT: Your Steam Mop needs water to make steam! Never use your steam mop without water in the tank.

Sweep or vacuum your floors prior to cleaning with your Steam Mop.

Visit www.sharkclean.com for other great quick cleaning products to complement your Steam Mop, such as the Shark® Navigator

(model NV350).

1Pull and twist the quick release cord holder to unwrap the power cord completely. Plug into a 120-volt electrical outlet. (fig. 6)

2The ON/STANDBY switch will flash blue. If the light does not turn on, reference the troubleshooting section on page 12. (fig. 7)

4 TOLL FREE: 1-800-798-7398

S3601CO_IB_110117.indd 4-5

www.sharkclean.com 5

1/17/11 4:28 PM