GETTING TO KNOW YOUR CYCLONIC BAGLESS
OPERATING INSTRUCTIONS
UPRIGHT
1. | Upper Handle | 10. | Flexible Hose |
2. | On/Off Switch | 11. | Power Cord |
3. | Dust Cup Release Button | 12. | Quick Release Power Cord Holder |
4. | Dust Cup | 13. | Round Brush |
5. | HEPA Filter Frame | 14. | Upholstery Brush |
6. | Carpet Height Selector | 15. | Crevice Tool |
7. | Furniture Guard | 16. | Extension Tubes (x2) |
8. | Head Light | 17. | Hose Connector |
Motor Thermostat
Important: This unit is equipped with a motor protective thermostat. If for some reason the vacuum cleaner should overheat, the thermostat will automatically turn the unit off. Should this occur:
•Push the On/Off button once.
•Disconnect the plug from the power source.
•Check the source of overheating problem. (i.e. clogged hose or filter)
•If clogged hose or filter is found, unclog the hose and replace the filters.
•Wait at least 45 minutes before attempting to reuse the vacuum.
•After unit has cooled down for 45 minutes, plug in the cleaner and push the On/Off button. The vacuum should start again.
•If the vacuum still does not start, contact customer service at
1 (800)
Cleaning & Changing the Belt
Warning: To reduce the risk of electric shock, the power cord must be disconnected before removing the dust cup, HEPA filter,changing the filters or performing maintenance/trouble shooting checks.
Occasionally the power nozzle drive belt will require changing, the frequency will depend upon the amount of use your vacuum sees.
1.Turn the vacuum "Off" and unplug from power supply.
2.Turn the vacuum upside down on a flat level surface.
3.With a coin or a thick flat head screwdriver, unlock the two (2) screw locks by turning counter- clockwise. (Fig. 21)
4.Remove the bottom cover of the power head.
5.Lift the right side of the agitator brush first and then lift the left hand side and lift the agitator brush out of the power head.
6.Carefully remove any belt residue that may exist in the belt area.
7.If the belt has broken, remove any loose pieces before replacing with a new belt.
8.Remove the worn or broken belt from the motor drive shaft.
9Loop the new belt first over the motor drive shaft and then over the agitator pulley. (Fig. 22)
Insert
First
Fig. 22
10.Insert the left side of the agitator in first by placing the end cap down into the slot and then do the same with the right side. Press firmly to make sure that each end is completely inserted.
11.Check to make sure that the belt is centered on the pulley and that the agitator turns freely.
12.Replace the top cover over the power head base and lock in place by turning the two screw locks clockwise until you hear them lock in place.
9. Motorized Power Head | 18. |
Technical Specifications
Voltage: | 120V., 60Hz. |
Power: | 12 Amps |
Note: Illustrations may differ from actual unit.
3
Fig. 21
4.Remove the bottom cover of the power head.
5.Lift the right side of the agitator brush first and then lift the left hand side and lift the agitator brush out of the power head.
8