OPERATING INSTRUCTIONS
PRECAUTIONARY MEASURES
Changing the Headlight Bulb
Warning: To reduce the risk of electric shock, the power cord must be disconnected before removing the dust cup, HEPA filter,changing the filters or performing maintenance/trouble shooting checks.
1.Turn unit “Off” and unplug from wall outlet.
2.With a flat head screw driver, snap off the lens cover by pressing down on the two notches on the lens cover. (Fig. 23)
3.Lift off the head light lens.
Notches
Fig. 23
4.Remove the light bulb by pulling it out carefully.
5.Replace the new bulb by pushing it in.
6.Replace the head light lens by pushing it in so that it snaps back in place.
Important: If the suction opening in the unit, the hose or the extension tube become blocked, switch off the vacuum cleaner and remove the blocking substance before you start the unit again.
1. Do not operate the vacuum | 5. When pulling out the power plug |
cleaner to close too heaters, | from the wall outlet, pull the plug |
or radiators. | not the power cord. |
PROBLEM SOLVING
This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem occurs, it usually can be solved quite easily when the cause is found. Therefore, this checklist is provided for your convenience.
PROBLEM |
| POSSIBLE CAUSE |
| POSSIBLE | |
| 1. | Not properly plugged into wall | 1. | Plug in firmly. | |
|
| outlet. | 2. | Check fuse or breaker. | |
Cleaner Won’t | 2. | No electricity in wall outlet. | 3. | Push on/off switch to on | |
Run | 3. | On/Off switch not turned on. | 4. | Reset motor thermostat. | |
| 4. | Motor thermostat tripped. |
| (page 8 ) | |
| 5. | Blown fuse/tripped breaker. | 5. | Reset circuit breaker or replace fuse. | |
|
|
|
|
| |
|
|
| 1. | Clean dust cup. (page 5) | |
| 1. | Full or clogged dust cup. | 2. | Adjust setting. (page 5) | |
| 2. | Wrong pile height setting. | 3. | Remove obstruction. | |
| 3. | Clogged nozzle. | 4. | Remove power head cover and | |
Cleaner Won't | 4. | Clogged dust inlet port. |
| remove obstruction. | |
Pick Up | 5. | Clogged hose. | 5. | Remove obstruction. | |
| 6. | Broken belt. | 6. | Replace belt. (page 8) | |
| 7. | Hose not inserted fully. | 7. | Push hose in securely. | |
| 8. | Dirty filters. | 8. | Clean / change filters. | |
|
|
|
| (page 6, 7) | |
|
|
|
|
| |
Cleaner Picks Up |
|
|
|
| |
Moveable Rugs | 1. | Wrong pile height setting. | 1. | Adjust setting. (page 5) | |
Or Pushes Too | |||||
|
|
|
| ||
Hard |
|
|
|
| |
|
|
|
|
| |
Agitator Does Not | 1. | Broken belt. | 1. | Replace belt. (page 8) | |
2. | Check belt changing and agitator | ||||
Turn | 2. | Belt installed incorrectly. | |||
| cleaning. (page 9) | ||||
|
|
|
| ||
|
|
|
|
| |
Air Flow | 1. | Attachment use restricts air |
|
| |
Restricted With |
| flow. | 1. | Check attachment. | |
Attachment Use | 2. | New carpet debris clogging | 2. | Remove obstruction. | |
Sound Changes |
| air path. |
|
| |
|
|
|
|
|
2.Before inserting the power plug into the wall outlet, make sure that your hands are dry.
3.Do not vacuum any liquids.
4.Keep hair, loose clothing, fingers, feet and all parts of body away from openings, rotating agitator and other moving parts.
6.Do not pick up anything that is burning or smoking such as cigarettes, matches or hot ashes.
7.Do not run appliance over power cord.
8.Do not use without dust cup filter or filters in place.
9.Before you start vacuuming, make sure to remove large or sharp objects that might damage the vacuum.
9 | 2 |
