Dishwasher runs too long
♦If the temperature of the water entering your dishwasher is below 120°, the dishwasher runs longer because it heats the water to the proper temperature for the program selected. Raising your water heater setting may help to shorten the cycle times.
Dishwasher does not drain properly
♦Make sure that the cycle was complete before you opened the dishwasher. If not, allow it to complete and check again.
♦Some water left in the sump area near the drain is normal.
♦If the plumbing code in your area requires an air gap, make sure that it isn’t blocked or plugged.
♦If the unit is connected to a garbage disposer, make sure the disposer is empty.
♦If water backs up into the sink, check the garbage disposer and trap for blockage.
♦Check the dishwasher filters and drain area for blockage. (See page 27.)
♦Check for a kink in the drain hose.
Dishwasher does not fill properly
♦Make sure the water supply is turned on.
♦Make sure the dishwasher is turned on and the door is closed securely.
♦Check for crimps in the water feed line.
♦Make sure the water inlet filter isn’t clogged. (See page 27.)
♦The system is designed to detect an overflow. When it does, it shuts off the circulation pump and turns on the drain pump. (See “Overfill Protection” on page 28.)
Dishwasher will not start
♦Make sure the dishwasher is turned on and the door is closed securely.
♦Make sure the Delay option is not selected.
♦Check that the water supply is connected properly and the water is turned on.
♦Make sure the power cord is properly plugged into the wall socket.
♦Check your fuse box for a blown fuse or tripped circuit breaker.
ERROR MESSAGES ON MODELS EDW154E, EDW174E, AND EDW194E
An error will display in the LCD window if a fault occurs while a program is in progress. The table below defines each error message.
ERROR | DEFINITION |
|
|
E1 | Fill fault. Check that the main water supply is turned on. If it is, call a service technician. |
|
|
E2 | Wash and heating fault. Call a service technician. |
|
|
E4 | Water fill fault. Call a service technician. |
|
|
E5 | Drain fault. Make sure that nothing is blocking the drain and that the outlet hose isn’t kinked. |
| If that is not the case, call a service technician |
|
|
E6 | Low water fault. Check that none of the dishes have overturned and collected water. If this is |
| not the case, call a service technician. |
|
|
E7 | Alternating spray arm fault. Call a service technician. |
|
|
ENGLISH
31
