Eurotech Appliances EDW194E, EDW154E, EDW174E Technical Data, Easy Connection, Water Supply

TECHNICAL DATA

Water pressure	18-176 psi
Power	110–120 v, 60 Hz
Heating element	1200 w
Max loading	1450 w

EASY CONNECTION

Your Eurotech comes with everything you need for an easy, problem-free installation:

nPEX tubing with 3/8” compression fitting—This tubing has a 50-year spec life. It fits American dishwasher water supply valves.

nDrain hose— Corrugated drain hose and holder to form a high loop.

nElectrical cord and plug—110-120 volts, 15 amp cord supplied with unit.

WARNING! Do not use an extension cord for this appliance.

WATER SUPPLY

WARNING! Plumbing connections must comply with applicable sanitary, safety and plumbing codes in your area.

The dishwasher comes with a 5-foot PEX water supply line that has a 3/8" NPT female connection. Be sure

to insert the black rubber washer (enclosed in the hardware package) into the PEX hose connection before you attach it to the water supply.

The electrical and water supplies should come through the right side of the machine, a maximum of 2” (50

mm)from the back wall and 6-1/4” to 8-1/4” (159–210 mm) from the floor, depending on the underneath cabinet height.

For service convenience, a shut-off valve (not supplied) should be installed in the water supply line in an easily accessible location, such as, beneath the sink.

It is important that the water supply line and the shut-off valve have a sufficient flow volume. At least 3 gallons (12 liters) per minute must be able to pass through the line. The water pressure should be 18-176 psi.

WARNING! In order to prevent heat damage to the inlet valve, all solder connections must be made before the water line is connected to the dishwasher.

NOTE: Be sure to run the PEX water supply line, drain line, and power supply cord through the hole to sink compartment before moving the dishwasher into position.

ENGLISH

(1)Water supply

(2)Water supply valve (not supplied)

9