EverFocus EFC--02-1-A user manual

Step 3: Using the software that you installed in Step 1 on the Installation PC, locate the EA-LAN1 on the local area network and change the IP address on the EA- LAN1.

Step 4: Configure the EA-LAN1 as described in the detailed description later in this guide.

Step 5: Connect the EA-LAN1 to the controller. (Note: Perform this step only after successfully completing steps 1-5)

Step 6: Install the “COM Port Simulator” driver on the Admin PC using the CD included with the EA-LAN1, and map the COM Port to be used.

Step 7: Confirm that the controller is now available on the network. At the Admin PC, open the EverAccess Flex Software and connect to the controller using the COM Port mapped in Step 7.

28