EverFocus EPTZ2700i user manual Alarm Link to a Position/Tour, ¾Set an alarm link

To preset a tour before running is necessary.

Preset a one-way tour: Press Set + Tour to preset a one-way tour. The system will ask you to enter preset position numbers (The positions need to be preset). After finish entering all positions, press Stop to quit, and then press Enter to save the tour.

¾To-and-fro tour mode: Press Shift + Tour to run a to-and-fro tour. The system will ask you to enter the tour number you would like to run, and starts the tour after pressing Enter. To preset a tour before running it is necessary.

Note 1: The difference between the One-way tour mode and To-and-fro tour mode is that

the return modes are different. For example: There is a tour with 3 preset positions 1, 2 and 3. The camera runs 1→2→3→1→2→3 in the One-way tour mode, and 1→2→3→2→1 in the To-and-fro tour mode.

Note 2: You could set a pattern tour. Press Set + Tour, and input 0, press Enter. Sway the joystick to record the entire tour. Press Stop to stop recording tour. To view this pattern tour, simply press Tour, and input tour number 0.

4.5. Alarm Link to a Position/Tour

EPTZ2700/EPTZ2700I have 4 alarm inputs that can be set to link to a position or a tour when an alarm is triggered.

¾Set an alarm link:

Press F1 to set an alarm link. Enter the alarm number, and then press Enter. Switch the Joystick up/down to select a position or a tour, enter a position or tour number, and then press Enter to confirm the alarm link setting.

If you set the position number to 99, the dome will do a 360 degree auto scan or AB two point pan if limit is ON. If you set the position number to 98, the dome will do

64