2.3. Initial Setup
Initial setup includes dome address, communication protocol, transmission speed, and terminal resistance settings. All of the settings should be confirmed before the dome is installed. The
Notice: Please make sure the power is off before setting, and restart the EPTZ2700/EPTZ2700I to enable a new value after changing.
2.3.1. Address Setting
The address code of the EPTZ2700/EPTZ2700I should be set to correspond properly with a control device to control multiple dome cameras. The address codes are made up by the dipswitch on the camera main body. The 8 bits dipswitch indicates the binary coded of the address, and there are 256 addresses can be selected (0 ~ 255). It also means that there are up to 256 dome cameras that can cascade on the
Note: The factory default address is 1.
Notice: Please make sure the power is off before setting, and restart the EPTZ2700/EPTZ2700I to enable a new value after changing.
15