- 17 -
5.4.4 SENSE-UP
SENSE-UP is used to keep a brilliant, vivid screen image under low light level conditions by
automatically compensating for changes in the level of light.
1. Please direct the arrow to point to “SENSE-UP” by using the UP and DOWN buttons.
2. Select the mode you would like to operate by pressing the LEFT or RIGHT button.
AUTO: Low light level auto mode.
OFF: The function is disabled.
3. Press select RETURN and the SETUP button when you finish all the settings.
5.4.5 BLC/BLC
Video gain can be adjusted automatically to correct the exposure of subjects that are in front of a bright
light source.
1. Please direct the arrow to point to “BLC” by using the UP and DOWN buttons.
2. Select the BLC mode by pressing the LEFT or RIGHT button. Then make adjustments as below:
GAIN: Select from High, Middle and Low.
DEFAULT: Set the factory default values for BLC.
LEFT/RIGHT: Set the Left/Right side of an area for the BLC to be adjusted. The value adjustable
is 0~6.
WIDTH: Set the width of an area for the BLC to be adjusted. The value adjustable is 0~6.
TOP/BOTTOM: Set the Top/Bottom side of an area for the BLC to be adjusted. The value
adjustable is 0~6.
NOTE:
○
1 When SHUTTER is in manual mode, SENSE-UP will be disabled.
○
2 When AGC is turned off, SENSE-UP will be disabled.
NOTES:
○
1 The maximum amplification in low light level situations can be adjusted by pressing the
SETUP button in “AUTO” mode. This sets an upper limit on the ‘boost’.
○
2 The image becomes brighter when the setting increases; however, the after image increases
as well. Due to the increased light sensitivity of the Super Had II chip, far less DSP ‘boost’ is
needed, resulting in color or B/W images in low light with minimal ghosting.
○
3 Please note that spots and noise may appear if light amplification increases when SENSE-UP
is operating. This is a normal phenomenon, controllable with DNR.