Hardware Installation

Installing the CPU Fan

There are many different fan types that can be used with this motherboard. Follow the instruction that came with you fan assembly. Be sure that the fan orientation is correct for your chassis type and your fan assembly.

Installing Memory DIMMs

Your new motherboard has four 1.8V 240-pin slots for DDR2 memory. These slots support 256 Mb, 512 Mb, 1 Gb, and 2GB DDR2 modules. They also support dual channel DDR2 memory technology up to 10.7GB/s. There must be at least one memory bank populated to ensure normal operation. Use the following the recommendations for installing memory. (See Figure 1 on page 9 for the location of the memory slots on the card)

‰One DIMM: Install into slot 0. You can install the DIMM into any slot, however, slot 0 is preferred.

‰Two DIMMs: Install into either slots 0 and 1 or 2 and 3. The idea is to not have the DIMMs in adjacent slots.

‰Four DIMMS: Install into slots 0, 1, 2, and 3.

CPU side

DIMM Slot 0

DIMM Slot 2

DIMM Slot 1

DIMM Slot 3

Card-edge side

Use the following procedure to install memory DIMMs into the slots on the motherboard. Note that there is only one gap near the center of the DIMM slot. This slot matches the slot on the memory DIMM to ensure the component is installed properly.

1.Unlock a DIMM slot by pressing the module clips outward.

2.Align the memory module to the DIMM slot, and insert the module vertically into the DIMM slot. The plastic clips at both sides of the DIMM slot automatically lock the DIMM into the connector.

13

Page 24
Image 24
EVGA 650I manual Installing the CPU Fan, Installing Memory DIMMs