Evolution Technologies OM-900M manual Monitoring Battery Energy Level, Installing the System

ASSEMBLY AND USE

MONITORING BATTERY ENERGY LEVEL:

The EVOLUTIONTM MOTION conserver is equipped with a low battery indicator light that alerts you when a battery change is needed.. The following signal will be displayed as your batteries

become depleted: Blinking red light – Low battery energy level.. Replace batteries..

Disposal of Batteries: Do not dispose of used batteries in the household waste.. Contact a public waste disposal authority for proper disposal instructions..

INSTALLING THE SYSTEM:

STEP 1: Loosen the cylinder adjustment handle..

STEP 2: Lower the EVOLUTIONTM MOTION conserver over any CGA 870 post-valve cylinder with the alignment pins toward the holes on the cylinder neck [Fig.. F]..

STEP 3: Align the two (2) pins and seal washer with the corresponding holes on the cylinder post valve..

STEP 4: While holding the unit in place, tighten the cylinder adjustment handle by turning clockwise [Fig.. F]..

* NOTE: Tighten only by hand. The use of a tool to tighten the handle may damage the unit.

FIGURE F

Attaching the EVOLUTIONTM

MOTION conserver to the cylinder

CAUTION! If you are unable to eliminate leaks by manually tightening the

cylinder adjustment handle, replace the seal washer.. If leaks persist, the unit must be returned for service..

STEP 5: Attach a standard cannula to the oxygen supply outlet.. See page 14 for an illustration demonstrating the proper positioning of the nasal cannula..

13