Setting Up
YourGame
First, make sure your
dartboard is powered; you can
install batteries as explained
in the “Installing Batteries”
section on page 3 or you can
use an adapter (not included)
to plug your dartboard into an
electrical socket.
Then, make sure your
dartboard is properly hung on
the wall.
Press any button to stop
the LCD auto-test scanning.
Press the GAME button to
select a desired game series,
and press the OPTION button to
select a desire game option.
Please refer to the Game
Name Chart on page 11. Once
you’ve found your desired
game series and game option,
press the CHANGE button to
confirm.
Press the OPTION button
to select a single, double, or
triple IN game and press the
CHANGE button to confirm.
11
To install your dartboard,
choose a suitable and safe
location. Be sure to choose a
location that is close to an
electrical wall outlet, if you
choose to use an adapter.
Excalibur recommends fol-
lowing the international stan-
dard for your dartboard’s
height and distance, as shown
on Figure 8.
According to the inter-
national standard, the center
of the Bull’s Eye should be
located five feet eight inches
(or 173 centimeters). The
throwing line should be seven
feet nine inches (or 237 cm).
To hang your dartboard in
this height, drill the upper
screw at a height of six feet
three and seven-eighth inches
(or 193 cm) from the floor.
Drill the lower screw exactly
one foot three and three-
fourths inches (or 40 cm)
below the upper screw. This
will be five feet one and one-
fifth inches (or 153 cm), as
shown on Figure 9.
After you’ve drilled the
screws into the walls at the
appropriate heights, carefully
hang your dartboard securely
on the two screws. Lightly
pull down on the dartboard to
insure it is securely in place
before letting go.
10